REAR STABILIZER BAR INSTALLATION

PROCEDURE


  1. INSTALL REAR STABILIZER BUSHING


    1. A01CQI4C02
      *1 Rear Stabilizer Bushing
      *a Bushing Stopper
      *b Rear Stabilizer Bushing Slit
      B002HVY Front of the Vehicle

      Install the 2 rear stabilizer bushings to the rear stabilizer bar on the outside of the bush stoppers as shown in the illustration.

      Note


      • Install the rear stabilizer bushing so that the bushing stopper of the rear stabilizer bar is facing the vehicle interior.

      • Install the rear stabilizer bushing so that the slit is in the position shown in the illustration.

  2. INSTALL REAR STABILIZER BAR


    1. A01CPERC01
      *a Paint Mark
      B002HVY Front of the Vehicle

      Install the rear stabilizer bar so that the paint mark is facing the right side of the vehicle.

  3. INSTALL REAR NO. 1 STABILIZER BAR BRACKET


    1. A01CQ2J

      Install the 2 rear No. 1 stabilizer bar brackets to the rear suspension member with the 4 nuts.

      Torque:
      60 N*m  { 612 kgf*cm, 44 ft.*lbf }

  4. INSTALL REAR STABILIZER LINK ASSEMBLY LH

    Note

    Since the rear stabilizer link, rear stabilizer cushions and nut (B) are not reusable, new parts must be installed.


    1. A01COMHC02
      B002HVY Nut (A)
      B002I10 Nut (B)

      Install a new rear stabilizer link assembly LH and 2 new rear stabilizer cushions to the rear No. 2 suspension arm assembly with a new nut (B) as shown in the illustration.

      Torque:
      30 N*m  { 306 kgf*cm, 22 ft.*lbf }

      Note

      Be sure to install the rear stabilizer cushions in the correct direction as shown in the illustration.

    2. Install the rear stabilizer link assembly LH to the rear stabilizer bar with the nut (A).

      Torque:
      74 N*m  { 755 kgf*cm, 55 ft.*lbf }

      Tech Tips

      If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.

    3. A01COAHN01

      Adjust the rear stabilizer link assembly LH so that A and B are parallel as shown in the illustration.

  5. INSTALL REAR STABILIZER LINK ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

  6. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

    Click here