REAR TRAILING ARM INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. TEMPORARILY INSTALL REAR TRAILING ARM ASSEMBLY LH


    1. Temporarily install the rear trailing arm assembly LH to the rear suspension arm bracket with the bolt and nut.

    2. Install the rear trailing arm assembly LH to the vehicle with the 3 bolts.

      Torque:
      80 N*m  { 816 kgf*cm, 59 ft.*lbf }

    3. Install the rear trailing arm assembly LH to the rear axle carrier with the 2 bolts.

      Torque:
      200 N*m  { 2039 kgf*cm, 148 ft.*lbf }

  2. TEMPORARILY INSTALL REAR SHOCK ABSORBER ASSEMBLY LH

    Click here

  3. CONNECT REAR SKID CONTROL SENSOR WIRE LH (for 2WD)


    1. w/o AVS:

      Click here

    2. w/ AVS:

      Click here

  4. CONNECT REAR SPEED SENSOR LH (for AWD)


    1. w/o AVS:

      Click here

    2. w/ AVS:

      Click here

  5. CONNECT PARKING BRAKE WIRE ASSEMBLY NO.1

    Click here

  6. STABILIZE SUSPENSION

    Click here

  7. TIGHTEN REAR TRAILING ARM ASSEMBLY LH


    1. Tighten the nut.

      Torque:
      150 N*m  { 1530 kgf*cm, 111 ft.*lbf }

  8. TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH

    Click here

  9. INSTALL NO. 1 FLOOR UNDER COVER

    Click here

  10. INSTALL REAR WHEEL

    Click here

  11. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

    Click here

  12. CHECK FOR SPEED SENSOR SIGNAL

    Click here

  13. PERFORM INITIALIZATION

    Click here