REAR SHOCK ABSORBER DISPOSAL

PROCEDURE


  1. DISPOSE OF REAR SHOCK ABSORBER ASSEMBLY LH

    A01CRAFC01
    *A w/o AVS
    *B w/ AVS

    1. Extend the piston rod and secure the rear shock absorber assembly at an angle in a vise.

    2. Using a drill, make a hole in the cylinder between A and B shown in the illustration to discharge the gas inside.

      CAUTION:

      Be careful when drilling as shards of metal may fly about. Always use proper safety equipment.

      Note

      The gas is colorless, odorless and non poisonous.