FRONT STABILIZER BAR INSTALLATION

PROCEDURE


  1. INSTALL FRONT STABILIZER BAR BUSHING LH

    A01COZ5C02
    *1 Stopper
    B002HVY Front of the Vehicle

    1. Install the front stabilizer bar bushing to the front stabilizer bar as shown in the illustration.

      Note


      • Install the front stabilizer bar bushing so that the cutouts face the rear of the vehicle.

      • Install the front stabilizer bar bushing LH so that the stopper of the front stabilizer bar is inside of the vehicle.

      • Make sure that the LH and RH bushing are installed in the proper locations.

  2. INSTALL FRONT STABILIZER BAR BUSHING RH

    Tech Tips

    Use the same procedure described for the LH side.

  3. INSTALL FRONT STABILIZER BAR


    1. Install the front stabilizer bar to the front suspension crossmember so that the identification mark is positioned on the right side of the vehicle.

      A01CR9EC02
      *a Identification Mark - -
      B002HVY Top of the Vehicle B002I10 Front of the Vehicle

  4. TEMPORARILY INSTALL FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH

    Click here

  5. INSTALL FRONT SUSPENSION MEMBER BRACE


    1. A01COAAC02
      *a Protrusion

      Install the front suspension member brace with the 8 bolts.

      Torque:
      92 N*m  { 938 kgf*cm, 68 ft.*lbf }

      Note

      After installing the front suspension member brace, make sure that the protrusions of the front stabilizer bar bushings are visible.

  6. INSTALL FRONT STABILIZER LINK ASSEMBLY LH


    1. Install the front stabilizer link assembly LH with the nut.

      Torque:
      74 N*m  { 755 kgf*cm, 55 ft.*lbf }

      Tech Tips

      If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud bolt.

  7. INSTALL FRONT STABILIZER LINK ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

  8. INSTALL FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY

    Click here