FRONT LOWER BALL JOINT INSTALLATION

CAUTION / NOTICE / HINT

Note


  • When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.

  • While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch is turned on. Therefore, even if only brake shoes are to be removed and installed, be sure to perform the Disable Brake Control procedure and disconnect the cable from the negative (-) terminal of the auxiliary battery before beginning work.

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL FRONT LOWER BALL JOINT ASSEMBLY LH


    1. Secure the front axle assembly between aluminum plates in a vise.

      Note

      When using a vise, do not overtighten it.

    2. Install the front lower ball joint to the front axle assembly with the nut.

      Torque:
      133 N*m  { 1356 kgf*cm, 98 ft.*lbf }

    3. Install a new clip.

      Note


      • If the holes for the clip are not aligned, align the holes by tightening the nut as necessary up to an additional 60°.

      • Make sure the claws of the clip are fully inserted into the grooves of the nut.

  2. INSTALL FRONT AXLE ASSEMBLY LH

    Click here