SUSPENSION CONTROL ECU INSTALLATION

PROCEDURE

1. INSTALL ABSORBER CONTROL ECU

   
   

   1. Install the absorber control ECU with the 2 bolts.

      Torque:

      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note

      
      

      • Avoid any impact to the absorber control ECU.

      • Do not drop the absorber control ECU. If it is dropped, replace it with a new one.

   2. Connect the clamp to the absorber control ECU.

   3. Connect the 2 connectors to the absorber control ECU.

2. INSTALL PARKING BRAKE ECU ASSEMBLY

   Click here

3. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH

   Click here

4. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

   Note

   
   

   • When disconnecting the cable from the negative (-) auxiliary battery terminal, some systems need to be initialized after the cable is reconnected.

     Click here

   • After replacing the absorber control ECU, it is necessary to perform registration of vehicle identification information. Vehicle identification information is automatically acquired when the system enters test mode.

     Click here

5. INSTALL DECK FLOOR BOX LH (w/ Spare Tire)

   Click here

6. INSTALL REAR DECK FLOOR BOX (w/ Spare Tire)

   Click here

7. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY (w/ Spare Tire)

   Click here