SUSPENSION CONTROL ECU REMOVAL

CAUTION / NOTICE / HINT

Note

While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch turns on. Therefore, when servicing the brake system components, do not operate the brake pedal or open/close the doors while the auxiliary battery is connected.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY (w/ Spare Tire)

    Click here

  3. REMOVE REAR DECK FLOOR BOX (w/ Spare Tire)

    Click here

  4. REMOVE DECK FLOOR BOX LH (w/ Spare Tire)

    Click here

  5. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

  6. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

    Click here

  7. REMOVE PARKING BRAKE ECU ASSEMBLY

    Click here

  8. REMOVE ABSORBER CONTROL ECU


    1. B002IKA

      Disconnect the 2 connectors from the absorber control ECU.

    2. Disconnect the clamp from the absorber control ECU.

    3. Remove the 2 bolts and absorber control ECU.

      Note


      • Avoid any impact to the absorber control ECU.

      • Do not drop the absorber control ECU. If it is dropped, replace it with a new one.