|DTC Code||DTC Name|
|C1783||Speed Signal Communication Error|
The speed sensors monitor the speed of the wheels and send an appropriate speed signal to the absorber control ECU through the skid control ECU (brake booster with master cylinder assembly).
If a malfunction occurs in either a front speed sensor or rear speed sensor, DTC C1783 is stored.
|DTC No.||Detection Item||DTC Detection Condition||Trouble Area||Warning Indicate|
|C1783||Speed Signal Communication Error||A speed sensor malfunction signal from the skid control ECU (brake booster with master cylinder assembly) is detected for 1 second or more.||
||Does not come on|
CAUTION / NOTICE / HINT
Before performing troubleshooting, inspect the connectors of related circuits.
If DTC C1782 (Power Source Voltage Malfunction) is output at the same time, perform troubleshooting for C1782 first.
Before replacing the absorber control ECU, perform all of the following again: 1) symptom simulation; 2) DTC inspection; and 3) GTS inspection (ECU Data List or Active Test Click here). If no malfunctions are found in other areas, replace the absorber control ECU.
When the absorber control ECU is replaced, switch to test mode and check that all test mode DTCs are cleared when their respective deletion conditions are met.
CHECK FOR DTC (CAN COMMUNICATION SYSTEM)
Check for DTCs.
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) Click here
CHECK FOR DTC (ELECTRONICALLY CONTROLLED BRAKE SYSTEM)
Check if DTC C1783 and an electronically controlled brake system speed sensor malfunction DTC are output.
REPLACE ABSORBER CONTROL ECU Click here
GO TO ELECTRONICALLY CONTROLLED BRAKE SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) Click here