REAR AXLE HUB REMOVAL

CAUTION / NOTICE / HINT

Note

When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.
While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch is turned on. Therefore, even if only brake shoes are to be removed and installed, be sure to perform the Disable Brake Control procedure and disconnect the cable from the negative (-) terminal of the auxiliary battery before beginning work.

Tech Tips

PROCEDURE

PRECAUTION

Note

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work.

Click here
DISABLE BRAKE CONTROL

Click here
REMOVE REAR WHEEL

Click here
REMOVE REAR AXLE SHAFT NUT LH (for AWD)
1. Using SST and a hammer, unstake the staked part of the rear axle shaft nut.
  
  SST
  
  09930-00010 ( 09931-00010, 09931-00020 )
  
  Note
  
  Loosen the staked part of the rear axle shaft nut completely, otherwise the screw of the drive shaft may be damaged.
2. While applying the brakes, remove the rear axle shaft nut.
DISCONNECT REAR DISC BRAKE CALIPER ASSEMBLY LH

Click here
REMOVE REAR DISC

Click here
DISCONNECT REAR SKID CONTROL SENSOR WIRE LH (for 2WD)
1. w/ AVS:
  
  Click here
2. w/o AVS:
  
  Click here
DISCONNECT REAR SPEED SENSOR LH (for AWD)
1. w/ AVS:
  
  Click here
2. w/o AVS:
  
  Click here
REMOVE REAR AXLE HUB AND BEARING ASSEMBLY LH (for 2WD)
1. Remove the 4 bolts and the rear axle hub and bearing assembly.
REMOVE REAR AXLE HUB AND BEARING ASSEMBLY LH (for AWD)
1. Remove the 4 bolts from the rear axle carrier.
2. Using a plastic-faced hammer, remove the rear axle hub and bearing assembly LH.