FRONT AXLE HUB BOLT REPLACEMENT

CAUTION / NOTICE / HINT

Note


  • When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.

  • While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch is turned on. Therefore, even if only brake shoes are to be removed and installed, be sure to perform the Disable Brake Control procedure and disconnect the cable from the negative (-) terminal of the auxiliary battery before beginning work.

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work.

    Click here

  2. DISABLE BRAKE CONTROL

    Click here

  3. REMOVE FRONT WHEEL

    Click here

  4. DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH


    1. B002I8V

      Remove the 2 bolts and disconnect the front disc brake caliper assembly from the steering knuckle.

      Note

      Use wire or an equivalent tool to keep the brake caliper from hanging down by the flexible hose.

  5. REMOVE FRONT DISC

    Click here

  6. REMOVE FRONT AXLE HUB BOLT LH

    B002K44C03
    *1 Nut
    *a Hold
    *b Turn

    1. Temporarily install 2 nuts and 2 washers to the front axle hub bolt as shown in the illustration.

    2. Using SST and a screwdriver or an equivalent tool to hold the front axle, remove the front axle hub bolt.

      SST
      09611-12010

  7. INSTALL FRONT AXLE HUB BOLT LH


    1. B002J80C02
      *1 Washer
      *2 Nut
      *a Hold
      *b Turn

      Install a washer and nut to a new front axle hub bolt as shown in the illustration.

    2. Using a screwdriver or an equivalent tool to hold the front axle, install the hub bolt by tightening the nut.

    3. Remove the nut and plate washer.

  8. INSTALL FRONT DISC

    Click here

  9. CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH


    1. Connect the front disc brake caliper assembly to the steering knuckle with the 2 bolts.

      Torque:
      106.8 N*m  { 1089 kgf*cm, 79 ft.*lbf }

  10. INSTALL FRONT WHEEL

    Click here

  11. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL


    1. Connect the cable to the negative (-) auxiliary battery terminal and tighten the nut.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

    2. w/o Spare tire:

      Install the battery service cover and attach the 2 claws.