STEERING WHEEL INSTALLATION

CAUTION / NOTICE / HINT

Note


  • Do not replace the spiral cable with sensor sub-assembly with the battery connected and the power switch on (IG).

  • Do not rotate the spiral cable with sensor sub-assembly when the following conditions are met: 1) The steering wheel is removed, 2) the battery is connected,and 3) the power switch is on (IG).

  • Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.

PROCEDURE


  1. INSTALL STEERING WHEEL HEATER CONTROL ASSEMBLY (w/ Steering Heater)

    Click here

  2. INSTALL TRANSMISSION SHIFT SWITCH ASSEMBLY (w/ Shift Paddle Switch)


    1. Install the transmission shift switch assembly with the new 4 screws.

  3. INSTALL CRUISE CONTROL SWITCH WIRE (w/ Cruise Control System)


    1. Install the cruise control switch wire to the cruise control main switch.

  4. INSTALL CRUISE CONTROL MAIN SWITCH (w/ Cruise Control System)

    Click here

  5. INSTALL STEERING SHAKE DAMPER


    1. Install the 2 screws and steering shake damper to the steering wheel assembly.

  6. INSTALL STEERING PAD SWITCH ASSEMBLY

    Click here

  7. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

  8. ADJUST SPIRAL CABLE

    Click here

  9. INSTALL STEERING WHEEL ASSEMBLY


    1. Align the matchmarks on the steering wheel assembly and steering main shaft.

    2. Install the steering wheel assembly set nut.

      Torque:
      50 N*m  { 510 kgf*cm, 37 ft.*lbf }

    3. w/ Steering Heater:

      Connect the connector of steering heater control assembly to the turn signal switch assembly with spiral cable.

    4. Connect the connectors to the turn signal switch assembly with spiral cable.

  10. INSTALL STEERING PAD

    Click here