SHIFT PADDLE SWITCH INSPECTION

PROCEDURE


  1. INSPECT TRANSMISSION SHIFT SWITCH ASSEMBLY


    1. B002HCUC02
      *a

      Component without harness connected

      (Transmission Shift Switch Assembly LH)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Transmission Shift Switch Assembly LH:
      Tester Connection Switch Condition Specified Condition
      2 (ECC) - 1 (SDN) "-" continuously pulled Below 2.5 Ω
      Released 1 MΩ or higher

      If the resistance values are not as specified, replace the transmission shift switch assembly LH.

    2. B002IOOC02
      *a

      Component without harness connected

      (Transmission Shift Switch Assembly RH)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Transmission Shift Switch Assembly RH:
      Tester Connection Switch Condition Specified Condition
      3 (SUP) - 2 (ECC) "+" continuously pulled Below 2.5 Ω
      Released 1 MΩ or higher

      If the resistance values are not as specified, replace the transmission shift switch assembly RH.

  2. INSPECT NO. 1 SWITCH WIRE


    1. Disconnect the No. 1 switch wire connector from the steering pad switch assembly.

    2. B002KBFC14
      *a

      No. 1 Switch Wire

      (to Steering Pad Switch Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      z7-2 (SDN) - z7-3 (ECC)

      "-" shift paddle operated and held

      (down-shift)

      		 Below 2.5 Ω

      "-" shift paddle not operated

      (down-shift)

      		 1 MΩ or higher
      z7-1 (SUP) - z7-3 (ECC)

      "+" shift paddle operated and held

      (up-shift)

      		 Below 2.5 Ω

      "+" shift paddle not operated

      (up-shift)

      		 1 MΩ or higher

      If the resistance value is not as specified, replace the No. 1 switch wire.