SHIFT LEVER POSITION SENSOR REMOVAL

PROCEDURE


  1. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY

    Click here

  2. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY


    1. B002IFN

      Remove the nut and disconnect the transmission control cable assembly from the control shaft lever.

    2. Remove the clip from the transmission control cable assembly.

  3. REMOVE SHIFT LEVER POSITION SENSOR


    1. A01CP2R

      Disconnect the shift lever position sensor connector.

    2. A01CR1W

      Remove the nut, washer, and control shaft lever from the manual valve shaft.

    3. A01CNJ3C03
      *1 Lock Plate
      *a Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, pry the tabs of the lock plate.

    4. A01CNSUC02
      *1 Lock Nut
      *2 Lock Plate

      Remove the lock nut and lock plate from the manual valve shaft.

    5. A01CPZ2

      Remove the 2 bolts and pull out the shift lever position sensor from the manual valve shaft.