CRUISE CONTROL MAIN SWITCH INSPECTION

PROCEDURE


  1. INSPECT CRUISE CONTROL MAIN SWITCH


    1. w/o Dynamic Radar Cruise Control System:


      1. Measure the resistance according to the value(s) in the table below.

        B002JZQC05
        *a

        Component without harness connected

        (Cruise Control Main Switch)

        		 - -
        Standard Resistance
        Tester Connection Condition Specified Condition
        1 (ECC) - 3 (CCS) Cruise control main switch (ON-OFF button) released 1 MΩ or higher
        Cruise control main switch (ON-OFF button) pushed Below 2.5 Ω
        +RES switch ON 236 to 244 Ω
        -SET switch ON 618 to 642 Ω
        CANCEL switch ON 1510 to 1570 Ω

        If the result is not as specified, replace the cruise control main switch.

    2. w/ Dynamic Radar Cruise Control System:


      1. Measure the resistance according to the value(s) in the table below.

        B002K6QC02
        *a

        Component without harness connected

        (Cruise Control Main Switch)

        		 - -
        Standard Resistance
        Tester Connection Condition Specified Condition
        1 (ECC) - 3 (CCS) Cruise control main switch (ON-OFF button) released 1 MΩ or higher
        Cruise control main switch (ON-OFF button) pushed Below 2.5 Ω
        +RES switch ON 236 to 244 Ω
        -SET switch ON 618 to 642 Ω
        CANCEL switch ON 1510 to 1570 Ω

        If the result is not as specified, replace the cruise control main switch.