ELECTRIC PARKING BRAKE ACTUATOR INSTALLATION

PROCEDURE


  1. INSTALL PARKING BRAKE ACTUATOR ASSEMBLY LH


    1. Apply a light coat of lithium soap base glycol grease to the new O-ring.

    2. Install the O-ring to the rear disc brake cylinder assembly LH.

    3. Using a 5 mm hexagon socket wrench, install the parking brake actuator assembly LH with the 2 bolts.

      Torque:
      8.4 N*m  { 86 kgf*cm, 74 in.*lbf }

  2. INSTALL PARKING BRAKE WIRE ASSEMBLY NO.1


    1. Connect the connector to the parking brake wire assembly.

    2. A0000DA

      Insert the claw of the parking brake wire bracket into the groove of the support bracket.

      Note

      Make sure that the claws of the parking brake wire bracket are facing toward the rear of the vehicle during installation.

    3. Install the parking brake wire bracket with the 4 bolts.

      Torque:
      6.0 N*m  { 61 kgf*cm, 53 in.*lbf }
    4. A0002AMN02

      Install the parking brake wire assembly with the 2 bolts and nut, and then connect the connector to the parking brake actuator assembly LH.

      Torque:
      Bolt (A)
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }
      Bolt (B)
      6.0 N*m  { 61 kgf*cm, 53 in.*lbf }
      Nut (C)
      16 N*m  { 163 kgf*cm, 12 ft.*lbf }

  3. INSTALL REAR WHEEL

    Click here