STEERING COLUMN ASSEMBLY(for Manual Tilt and Manual Telescopic Steering Column) REASSEMBLY

CAUTION / NOTICE / HINT

Note


  • When using a vise, place aluminum plates between the part and vise.

  • When using a vise, do not overtighten it.

PROCEDURE


  1. INSTALL POWER STEERING MOTOR ASSEMBLY

    Note


    • Do not drop the power steering ECU with motor assembly, strike it with tools or subject it to impacts.

    • If the power steering ECU with motor assembly is subjected to an impact, replace it with a new one.

    • Do not pull the wire harness of the power steering ECU with motor assembly.

    • Do not allow any moisture to come into contact with the power steering ECU with motor assembly.

    • Do not loosen any bolts not mentioned in the procedure.

    • Do not allow any foreign matter to contaminate the power steering ECU with motor assembly.


    1. Apply grease to the spline part of the power steering motor assembly.

    2. B002JYH

      Install the power steering motor assembly with the 2 bolts.

      Torque:
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

    3. Place new heat resistant tape.

      Note

      As heat from the power steering motor assembly may generate smoke, use heat resistant tape (resistant to 100°C (212°F) or higher).

  2. INSTALL POWER STEERING ECU ASSEMBLY

    Click here

  3. INSTALL WIRE HARNESS BRACKET


    1. B002IGHC01
      B002IB3 Install in this Direction

      Push in the direction shown in the illustration to attach the guide.

    2. B002H4JC01
      B002IB3 Install in this Direction (1)
      B002JX0 Install in this Direction (2)

      Push down in the direction (1) indicated by the arrow shown in the illustration, and push in direction (2) to attach the claw and install the bracket to the steering column assembly.

  4. INSTALL STEERING LOCK ACTUATOR ASSEMBLY

    Tech Tips

    When replacing the steering lock actuator assembly, refer to the Service Bulletin.


    1. Temporarily install the steering lock actuator assembly with a new tapered-head bolt.

      Note

      Be sure to use a new tapered-head bolt.

    2. B002HSX

      Tighten the tapered-head bolt until the bolt head breaks off.