STEERING WHEEL REMOVAL

CAUTION / NOTICE / HINT

Note


  • Do not replace the spiral cable with sensor sub-assembly with the battery connected and the power switch on (IG).

  • Do not rotate the spiral cable with sensor sub-assembly when the following conditions are met: 1) The steering wheel is removed, 2) the battery is connected,and 3) the power switch is on (IG).

  • Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.

PROCEDURE


  1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

  2. REMOVE STEERING PAD

    Click here

  3. REMOVE STEERING WHEEL ASSEMBLY


    1. Disconnect each connector from the spiral cable with sensor sub-assembly.

    2. B002IXY

      w/o Steering Wheel Vibration:


      1. Disconnect the connector.

    3. B002HLS

      w/ Steering Wheel Vibration:


      1. Disconnect the connector.

    4. B002K2XC04
      *a Matchmark

      Remove the steering wheel assembly set nut.

    5. Put matchmarks on the steering wheel assembly and steering main shaft.

    6. B002K72C02
      *a Hold
      *b Turn

      Using SST, remove the steering wheel assembly.

      SST
      09950-50013   ( 09951-05010, 09952-05010, 09953-05020, 09954-05021 )

      Note

      Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.

  4. REMOVE CRUISE CONTROL MAIN SWITCH

    Click here

  5. REMOVE STEERING PAD SWITCH ASSEMBLY

    Click here

  6. REMOVE SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)

    Click here

  7. REMOVE STEERING WHEEL HEATER CONTROL ASSEMBLY (w/ Steering Heater)


    1. w/o Steering Wheel Vibration:

      Click here

    2. w/ Steering Wheel Vibration:

      Click here

  8. REMOVE STEERING SHAKE DAMPER


    1. B002H83

      Remove the 2 screws and steering shake damper from the steering wheel assembly.