STEERING WHEEL REMOVAL

CAUTION / NOTICE / HINT

Note


  • Do not replace the spiral cable with sensor sub-assembly with the battery connected and the power switch on (IG).

  • Do not rotate the spiral cable with sensor sub-assembly when the following conditions are met: 1) The steering wheel is removed, 2) the battery is connected,and 3) the power switch is on (IG).

  • Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.

PROCEDURE


  1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

  2. REMOVE STEERING PAD

    Click here

  3. REMOVE STEERING WHEEL ASSEMBLY


    1. B002ITY

      Disconnect the connectors from the turn signal switch assembly with spiral cable.

    2. B002K32

      w/ Steering Heater:

      Disconnect the connector of steering heater control assembly from the turn signal switch assembly with spiral cable.

    3. B002K2XC04
      *a Matchmark

      Remove the steering wheel assembly set nut.

    4. Put matchmarks on the steering wheel assembly and steering main shaft.

    5. B002K72C02
      *a Hold
      *b Turn

      Using SST, remove the steering wheel assembly.

      SST
      09950-50013   ( 09951-05010, 09952-05010, 09953-05020, 09954-05021 )

      Note

      Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.

  4. REMOVE STEERING PAD SWITCH ASSEMBLY

    Click here

  5. REMOVE STEERING SHAKE DAMPER


    1. B002L01

      Remove the 2 screws and steering shake damper from the steering wheel assembly.

  6. REMOVE CRUISE CONTROL MAIN SWITCH (w/ Cruise Control System)

    Click here

  7. REMOVE CRUISE CONTROL SWITCH WIRE (w/ Cruise Control System)


    1. Remove the cruise control switch wire from the cruise control main switch.

  8. REMOVE TRANSMISSION SHIFT SWITCH ASSEMBLY (w/ Shift Paddle Switch)


    1. B002K8B

      Remove the 4 screws and transmission shift switch assembly.

  9. REMOVE STEERING WHEEL HEATER CONTROL ASSEMBLY (w/ Steering Heater)

    Click here