HEATED OXYGEN SENSOR INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL HEATED OXYGEN SENSOR

   

   *a	Torque Wrench Fulcrum Length

   Tech Tips

   Perform "Inspection After Repairs" after replacing the heated oxygen sensor.

   w/ Canister Pump Module:

   Click here

   
   

   1. Using SST, install the heated oxygen sensor to the front exhaust pipe sub-assembly.

      SST

      09224-00010

      Torque
      Specified tightening torque
      44 N*m (449 kgf*cm, 32 ft.*lbf)

      Note

      Replace with a new part if it is dropped or if it receives a strong impact.

      Tech Tips

      
      

      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 37.7 N*m (384 kgf*cm, 28 ft.*lbf)

   2. Connect the heated oxygen sensor connector.

2. INSTALL FRONT EXHAUST PIPE SUB-ASSEMBLY

   Click here

3. INSPECT FOR EXHAUST GAS LEAK

   Click here