HEATED OXYGEN SENSOR INSTALLATION

PROCEDURE


  1. INSTALL HEATED OXYGEN SENSOR

    B002HVWC01
    *a Torque Wrench Fulcrum Length

    1. Using SST, install the heated oxygen sensor to the front exhaust pipe sub-assembly.

      SST
      09224-00010
      Torque
      Specified tightening torque
      44 N*m (449 kgf*cm, 32 ft.*lbf)

      Note

      Replace with a new part if it is dropped or if it receives a strong impact.

      Tech Tips


      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 37.7 N*m (384 kgf*cm, 28 ft.*lbf)

    2. Connect the heated oxygen sensor connector.

  2. INSTALL FRONT EXHAUST PIPE SUB-ASSEMBLY

    Click here

  3. INSPECT FOR EXHAUST GAS LEAK

    Click here