CANISTER(w/ Canister Pump Module) REMOVAL

PROCEDURE

1. REMOVE FRONT FLOOR COVER CENTER LH

   Click here

2. REMOVE CHARCOAL CANISTER ASSEMBLY

   
   

   1. 

      *1	Vent Line Hose
      *2	Air Inlet Line Hose
      *3	Purge Line Hose
      *4	Retainer
      *a	Pull Out

      Disconnect the connector from the canister pump module.

   2. Slide the clamp and disconnect the purge line hose from the charcoal canister assembly.

   3. Disconnect the air inlet line hose from the air inlet line port.

      
      

      1. Pinch the retainer and then pull out it.

         Note

         
         

         • Do not use any tools in this procedure.

         • Check for any dirt and foreign matter contamination in the charcoal canister assembly and around the air inlet line hose. Clean if necessary. Foreign matter may damage the O-ring or cause leaks in the seal between the charcoal canister assembly and air inlet line hose.

         • When disconnecting the air inlet line hose, make sure that the retainer is not lifted.

   4. Disconnect the vent line hose from the charcoal canister assembly.

      
      

      1. Pinch the retainer and then pull out it.

         Note

         
         

         • Do not use any tools in this procedure.

         • Check for any dirt and foreign matter contamination in the charcoal canister assembly and around the vent line hose. Clean if necessary. Foreign matter may damage the O-ring or cause leaks in the seal between the charcoal canister assembly and vent line hose.

   5. 

      Remove the 4 bolts, clip and charcoal canister assembly.

3. REMOVE CANISTER PUMP MODULE

   
   

   1. Before removing the canister pump module, clean the charcoal canister assembly by blowing air into it to ensure that the charcoal canister assembly is free of foreign matter.

      Note

      
      

      • Make sure to clean the charcoal canister assembly using only air.

      
      

      • Do not use gasoline, thinners or solvents.

   2. 

      *a	Protective Tape

      While disengaging the 2 claws as shown in the illustration, push the canister pump module upwards using a screwdriver to remove it.

      Tech Tips

      Tape the screwdriver tip before use.

   3. 

      Check if the charcoal canister assembly contains foreign matter such as mud or water.

      
      

      1. Visually check that the inside of the charcoal canister assembly is free of foreign matter.

      2. Hold the charcoal canister assembly upside down to make sure that the charcoal canister assembly is free of foreign matter.

         If the charcoal canister assembly contains foreign matter, replace the charcoal canister assembly.