REAR CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL REAR ENGINE OIL SEAL


    1. Apply MP grease to the lip of a new rear engine oil seal.

      Note


      • Do not allow foreign matter to contact the lip of the rear engine oil seal.

      • Do not allow MP grease to contact the dust seal.

    2. A01COPSC02
      *a 0 to 0.9 mm (0 to 0.0354 in.) (from edge of cylinder block)

      Using SST and a hammer, tap in the rear engine oil seal until its surface is flush with the edges of the cylinder block and crankcase.

      SST
      09223-15030
      09950-70010   ( 09951-07150 )
      Standard
      0 to 0.9 mm (0 to 0.0354 in.) (from edge of cylinder block)

      Note


      • Keep the lip of the rear engine oil seal free from foreign matter.

      • Do not tap in the rear engine oil seal at an angle.

  2. INSTALL FLYWHEEL SUB-ASSEMBLY


    1. A01CPFEN01

      Using SST, hold the crankshaft pulley assembly.

      SST
      09213-54015
      09330-00021

      Tech Tips

      Part number of installation bolt for SST (crankshaft pulley holding tool): 91551-80650 (quantity: 2)

    2. Clean the bolts and bolt holes.

    3. Apply adhesive to 2 or 3 threads at the end of each of the 8 bolts.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
    4. A01CQQXN02

      Install the flywheel sub-assembly with the 8 bolts. Uniformly tighten the 8 bolts in the sequence shown in the illustration.

      Torque:
      130 N*m  { 1326 kgf*cm, 96 ft.*lbf }

  3. INSTALL TRANSMISSION INPUT DAMPER ASSEMBLY


    1. A01CPFEN01

      Using SST, hold the crankshaft pulley assembly.

      SST
      09213-54015
      09330-00021

      Tech Tips

      Part number of installation bolt for SST (crankshaft pulley holding tool): 91551-80650 (quantity: 2)

    2. A01COE9N02

      Install the transmission input damper assembly with the 6 bolts. Uniformly tighten the 6 bolts in the sequence shown in the illustration.

      Torque:
      30 N*m  { 306 kgf*cm, 22 ft.*lbf }

      Note


      • Make sure that there is no oil on the transmission input damper assembly and flywheel sub-assembly.

      • Make sure that the forward/backward direction of the transmission input damper assembly is correct before installation.

      • Do not allow grease to contact the splines of the transmission input damper assembly or the input shaft.

  4. INSTALL HYBRID VEHICLE TRANSAXLE ASSEMBLY

    Click here