REAR CRANKSHAFT OIL SEAL REMOVAL

PROCEDURE


  1. REMOVE HYBRID VEHICLE TRANSAXLE ASSEMBLY

    Click here

  2. REMOVE TRANSMISSION INPUT DAMPER ASSEMBLY


    1. A01CPFEN02

      Using SST, hold the crankshaft pulley assembly.

      SST
      09213-54015
      09330-00021

      Tech Tips

      Part number of installation bolt for SST (crankshaft pulley holding tool): 91551-80650 (quantity: 2)

    2. A01COE9

      Remove the 6 bolts and transmission input damper assembly.

  3. REMOVE FLYWHEEL SUB-ASSEMBLY


    1. A01CPFEN01

      Using SST, hold the crankshaft pulley assembly.

      SST
      09213-54015
      09330-00021

      Tech Tips

      Part number of installation bolt for SST (crankshaft pulley holding tool): 91551-80650 (quantity: 2)

    2. A01CQQX

      Remove the 8 bolts, then remove the flywheel sub-assembly.

  4. REMOVE REAR ENGINE OIL SEAL


    1. A01CPWVC06
      *a Cut Position
      *b Protective Tape

      Using a knife, cut off the lip of the rear engine oil seal.

    2. Using a screwdriver, pry out the rear engine oil seal.

      Note

      Do not damage the surface of the rear engine oil seal press fit hole or the crankshaft.

      Tech Tips

      Tape the screwdriver tip before use.