BATTERY COOLING FILTER INSTALLATION

PROCEDURE

1. INSTALL NO. 3 BATTERY SERVICE COVER BOARD

   
   

   1. for Power Seat:

      Connect the wire harness clamp and power seat switch connector.

   2. Attach the 2 claws and install the No. 3 battery service cover board.

   3. Install the 2 clips.

2. INSTALL NO. 2 BATTERY SERVICE COVER BOARD

   Tech Tips

   Use the same procedure as for the No. 2 battery service cover board.

3. INSTALL RECLINING ADJUSTER RELEASE HANDLE LH (for Manual Seat)

   Click here

4. INSTALL RECLINING ADJUSTER RELEASE HANDLE RH (for Manual Seat)

   Click here

5. INSTALL REAR DOOR SCUFF PLATE LH

   Click here

6. INSTALL REAR DOOR SCUFF PLATE RH

   Click here

7. INSTALL REAR SEAT CUSHION ASSEMBLY

   for Manual seat: Click here

   for Power seat: Click here

8. INSTALL CLEAR DTC

   Click here

   Tech Tips

   If the message "Maintenance required for hybrid battery cooling parts at your dealer" is displayed on the multi-information display in the combination meter assembly, clean or replace the No. 2 and No. 3 battery service cover board, and clear the DTCs to reset the learning values even if no DTCs are output.