АВТОМАТИЧЕСКАЯ ТРАНСМИССИЯ В СБОРЕ (если опорный мост двигателя используется) УЗЛЫ И ДЕТАЛИ
ILLUSTRATION
| *1 | OUTER COWL TOP PANEL SUB-ASSEMBLY | - | - |
 |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | FRONT FENDER APRON SEAL LH | *2 | FRONT FENDER APRON SEAL RH |
| *3 | FRONT FENDER LINER LH | *4 | FRONT FENDER LINER RH |
| *5 | NO. 1 ENGINE UNDER COVER | *6 | NO. 2 ENGINE UNDER COVER |
| *7 | FRONT FLOOR COVER LH | - | - |
ILLUSTRATION
| *1 | ENGINE WIRE | *2 | TRANSMISSION CONTROL CABLE ASSEMBLY |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *1 | FRONT EXHAUST PIPE ASSEMBLY | *2 | COMPRESSION SPRING |
| *3 | NO. 1 EXHAUST PIPE SUPPORT BRACKET (for Lower Side) | *4 | FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY |
| *5 | GASKET | *6 | MANIFOLD STAY |
| *7 | EXHAUST MANIFOLD (TWC: Front Catalyst) | *8 | EXHAUST MANIFOLD TO HEAD GASKET (for Bank 1) |
| *9 | AIR FUEL RATIO SENSOR (for Bank 1) | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *1 | FRONT DRIVE SHAFT ASSEMBLY | *2 | STEERING INTERMEDIATE SHAFT ASSEMBLY |
| *3 | FRONT STABILIZER LINK ASSEMBLY LH | *4 | FRONT SPEED SENSOR |
| *5 | TIE ROD ASSEMBLY LH | *6 | FRONT AXLE SHAFT NUT |
| *7 | COTTER PIN | *8 | FRONT FLEXIBLE HOSE |
| *9 | FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
 |
Do not apply lubricants to the threaded parts | - | - |
ILLUSTRATION
| *1 | WINDSHIELD WASHER JAR ASSEMBLY | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | FRONT DRIVE SHAFT ASSEMBLY LH | *2 | FRONT DRIVE SHAFT ASSEMBLY RH |
| *3 | FRONT DRIVE SHAFT HOLE SNAP RING | *4 | FRONT DRIVE SHAFT OIL SEAL LH |
| *5 | FRONT DRIVE SHAFT OIL SEAL RH | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
 |
MP grease | - | - |
ILLUSTRATION
| *1 | VENTILATION HOSE | *2 | PURGE VALVE (PURGE VSV) |
| *3 | NO. 1 FUEL VAPOR FEED HOSE | *4 | NO. 2 SURGE TANK STAY |
| *5 | INTAKE AIR SURGE TANK ASSEMBLY | *6 | AIR SURGE TANK TO INTAKE MANIFOLD GASKET |
| *7 | VACUUM HOSE SUB-ASSEMBLY | *8 | NO. 2 AIR TUBE |
| *9 | WIRE HARNESS CLAMP BRACKET | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
| |
Do not apply lubricants (to the threaded parts) | - | - |
ILLUSTRATION
| *1 | ENGINE MOUNTING INSULATOR LH | *2 | ENGINE MOUNTING INSULATOR RH |
| *3 | FRONT ENGINE MOUNTING INSULATOR ASSEMBLY | *4 | FRONT FRAME ASSEMBLY |
| *5 | HOLE PLUG | *6 | REAR ENGINE MOUNTING INSULATOR ASSEMBLY |
| *7 | TRANSMISSION OIL THERMOSTAT | *8 | FRAME SIDE RAIL PLATE LH |
| *9 | FRAME SIDE RAIL PLATE RH | *10 | FRONT SUSPENSION MEMBER REAR BRACE LH |
| *11 | FRONT SUSPENSION MEMBER REAR BRACE RH | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | AUTOMATIC TRANSAXLE ASSEMBLY | *2 | DRIVE PLATE AND TORQUE CONVERTER ASSEMBLY SETTING BOLT |
| *3 | EARTH WIRE | *4 | FLYWHEEL HOUSING UNDER COVER |
| *5 | TORQUE CONVERTER ASSEMBLY | *6 | MANIFOLD STAY |
| *a | BLACK COLOR: x 1 SILVER COLOR: x 5 |
- | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | |
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent |
 |
Clutch spline grease | ★ | Precoated part |
ILLUSTRATION
| *1 | INLET NO. 2 OIL COOLER HOSE | *2 | NO. 1 OIL COOLER TUBE SUB-ASSEMBLY WITHOUT HOSE |
| *3 | NO. 1 TRANSMISSION OIL COOLER HOSE | *4 | NO. 3 WATER BY-PASS HOSE |
| *5 | NO. 4 WATER BY-PASS HOSE | *6 | OUTLET NO. 1 OIL COOLER HOSE |
| *7 | OUTLET NO. 3 OIL COOLER HOSE | *8 | TRANSMISSION OIL COOLER |
| *9 | TRANSMISSION OIL THERMOSTAT | *10 | INLET NO. 1 OIL COOLER HOSE |
| *11 | OUTLET NO. 2 OIL COOLER HOSE | *12 | NO. 2 TRANSMISSION OIL COOLER HOSE |
| *13 | TRANSMISSION OIL COOLER TUBE CLAMP | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | BREATHER PLUG HOSE | *2 | NO. 1 TRANSMISSION CONTROL CABLE BRACKET |
| *3 | ENGINE MOUNTING BRACKET LH | *4 | FRONT ENGINE MOUNTING BRACKET |
| *5 | WIRE HARNESS CLAMP BRACKET | *6 | BREATHER PLUG SUB-ASSEMBLY |
| *7 | RADIATOR PIPE ASSEMBLY | *8 | TRANSMISSION CASE PLUG ASSEMBLY |
| *9 | NO. 3 WATER BY-PASS HOSE | *10 | NO. 4 WATER BY-PASS HOSE |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
| |
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent | - | - |