ЖГУТ ЭЛЕКТРОПРОВОДКИ ТРАНСМИССИИ (если опорный мост двигателя используется) УЗЛЫ И ДЕТАЛИ
ILLUSTRATION
| *1 | OUTER COWL TOP PANEL SUB-ASSEMBLY | - | - |
 |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | COOL AIR INTAKE DUCT SEAL | *2 | FRONT FENDER APRON SEAL LH |
| *3 | FRONT FENDER APRON SEAL RH | *4 | FRONT FENDER LINER LH |
| *5 | FRONT FENDER LINER RH | *6 | NO. 1 ENGINE UNDER COVER |
| *7 | RADIATOR SIDE DEFLECTOR SEAL LH | *8 | RADIATOR SIDE SEAL RH |
ILLUSTRATION
| *1 | AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE | *2 | BATTERY |
| *3 | INLET AIR CLEANER ASSEMBLY | *4 | V-BANK COVER SUB-ASSEMBLY |
| *5 | BATTERY TRAY | *6 | BATTERY CLAMP |
| *7 | BATTERY CLAMP BOLT | *8 | NO. 1 FUEL VAPOR FEED HOSE |
| *9 | NO. 2 VENTILATION HOSE | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | VENTILATION HOSE | *2 | PURGE VALVE (PURGE VSV) |
| *3 | NO. 1 FUEL VAPOR FEED HOSE | *4 | NO. 2 SURGE TANK STAY |
| *5 | INTAKE AIR SURGE TANK ASSEMBLY | *6 | AIR SURGE TANK TO INTAKE MANIFOLD GASKET |
| *7 | VACUUM HOSE SUB-ASSEMBLY | *8 | NO. 2 AIR TUBE |
| *9 | WIRE HARNESS CLAMP BRACKET | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
 |
Do not apply lubricants (to the threaded parts) | - | - |
ILLUSTRATION
| *1 | TRANSMISSION OIL THERMOSTAT | *2 | OUTLET NO. 1 OIL COOLER HOSE |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *A | for AISIN AW Made | *B | for TMC Made |
| *1 | TRANSMISSION CASE SIDE COVER | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | * | For use with a union nut wrench |
| ● | Non-reusable part |  |
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent |
| ★ | Precoated part | - | - |
ILLUSTRATION
| *1 | OIL COOLER UNION SUB-ASSEMBLY | *2 | OIL COOLER UNION BOLT |
| *3 | TRANSMISSION WIRE | *4 | TEMPERATURE SENSOR CLAMP |
| *5 | GASKET | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
| |
Toyota Genuine ATF WS | - | - |