BLACK OUT TAPE(for Front Door) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH

    Click here

  4. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  5. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)

    Click here

  6. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)

    Click here

  7. REMOVE COURTESY LIGHT ASSEMBLY

    Click here

  8. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  9. REMOVE FRONT DOOR SERVICE HOLE COVER

    Click here

  10. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY

    Click here

  11. REMOVE FRONT DOOR GLASS RUN

    Click here

  12. DISCONNECT FRONT DOOR WEATHERSTRIP

    Click here

  13. REMOVE DOOR FRAME GARNISH

    Click here

  14. REMOVE FRONT DOOR UPPER INNER BLACK OUT TAPE


    1. Using a heat light, heat the front door upper inner black out tape and vehicle body.

      Heating Temperature
      Item Temperature
      Front Door Upper Inner Black Out Tape and Vehicle Body 40 to 60°C (104 to 140°F)

      Note

      Do not heat the vehicle body excessively.

    2. A002BUZ

      Pull back on one of the ends of the front door upper inner black out tape to remove it.

      Tech Tips

      When pulling on the front door upper inner black out tape, pull it parallel to the body.

  15. REMOVE FRONT DOOR REAR INNER BLACK OUT TAPE


    1. Using a heat light, heat the front door rear inner black out tape and vehicle body.

      Heating Temperature
      Item Temperature
      Front Door Rear Inner Black Out Tape and Vehicle Body 40 to 60°C (104 to 140°F)

      Note

      Do not heat the vehicle body excessively.

    2. A002C65

      Pull back on one of the ends of the front door rear inner black out tape to remove it.

      Tech Tips

      When pulling on the front door rear inner black out tape, pull it parallel to the body.