WHEEL OPENING MOULDING(for Rear Side) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE REAR QUARTER PANEL MUDGUARD (w/ Mudguard)

    Click here

  2. REMOVE QUARTER PANEL WHEEL OPENING MOULDING


    1. A01QW2C

      w/o Mudguard:


      1. Remove the 3 screws.

      2. Remove the 4 clips.

    2. A01QWGX

      w/ Mudguard:


      1. Remove the 2 screws.

      2. Remove the 4 clips.

    3. While pulling the rear bumper assembly, insert a finger between the rear bumper side seal LH and rear bumper assembly and disengage the 4 claws by pushing the area shown in the illustration.

      A01QUY0C01
      *1 Quarter Panel Wheel Opening Moulding *2 Rear Bumper Assembly
      *3 Rear Bumper Side Seal - -
      *a Push - -

      Note

      To avoid damaging the claws, do not forcibly pull the quarter panel wheel opening moulding.

      Tech Tips

      Disengage the claws in the order shown in the illustration.

    4. Disengage the 4 clips to remove the quarter panel wheel opening moulding.