REAR DOOR BELT MOULDING INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL REAR DOOR BELT MOULDING ASSEMBLY


    1. A002AKN

      Engage the 7 claws to install the rear door belt moulding assembly.

  2. INSTALL REAR DOOR GLASS SUB-ASSEMBLY

    Click here

  3. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY

    Click here

  4. INSTALL REAR DOOR GLASS RUN

    Click here

  5. CONNECT REAR DOOR WEATHERSTRIP

    Click here

  6. INSTALL REAR DOOR PANEL PROTECTOR

    Click here

  7. INSTALL REAR DOOR SERVICE HOLE COVER

    Click here

  8. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  9. INSTALL REAR DOOR REAR GUIDE SEAL

    Click here

  10. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL

    Click here

  11. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  13. INITIALIZE POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on 4 Windows)

    Click here

  14. INSPECT POWER WINDOW OPERATION


    • for Models with Jam Protection Function on 4 Windows:

      Click here


    • for Models with Jam Protection Function on Front Door Windows:

      Click here