REAR DOOR OUTSIDE MOULDING REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE REAR DOOR LOWER OUTSIDE MOULDING SUB-ASSEMBLY

    Tech Tips

    When removing the rear door lower outside moulding sub-assembly, heat the vehicle body and rear door lower outside moulding sub-assembly using a heat light.

    Heating Temperature
    Item Temperature
    Vehicle Body 40 to 60°C (104 to 140°F)
    Rear Door Lower Outside Moulding Sub-assembly 20 to 30°C (68 to 86°F)

    Note

    Do not heat the vehicle body or rear door lower outside moulding sub-assembly excessively.


    1. A018HGH

      Remove the screw.

    2. Remove the 2 clips.

    3. A018K98

      Disengage the clip and turn back the rear door lower outside moulding sub-assembly as shown in the illustration.

    4. A018HE8C01
      B004057 Protective Tape

      Apply protective tape around the rear door lower outside moulding sub-assembly as shown in the illustration.

    5. A018ILOC01
      *a Double-sided Tape

      Disengage the 5 clips and separate the double-sided tape to remove the rear door lower outside moulding sub-assembly.

  2. REMOVE REAR DOOR OUTSIDE MOULDING SUB-ASSEMBLY

    Tech Tips

    When removing the rear door outside moulding sub-assembly, heat the vehicle body and rear door outside moulding sub-assembly using a heat light.

    Heating Temperature
    Item Temperature
    Vehicle Body 40 to 60°C (104 to 140°F)
    Rear Door Outside Moulding Sub-assembly 20 to 30°C (68 to 86°F)

    Note

    Do not heat the vehicle body or rear door outside moulding sub-assembly excessively.


    1. A018K6Q

      Disengage the 4 clips and turn back the rear door outside moulding sub-assembly as shown in the illustration.

    2. A018K27

      Remove the hole plug.

    3. A018HDE

      Remove the nut.

    4. A018I7BC01
      B004057 Protective Tape

      Apply protective tape around the rear door outside moulding sub-assembly as shown in the illustration.

    5. A018H2AC01
      *a Double-sided Tape

      Disengage the 8 clips and separate the double-sided tape to remove the rear door outside moulding sub-assembly.

    6. Remove the 8 clips.

    7. Remove the gasket.

  3. REMOVE REAR DOOR UPPER OUTSIDE MOULDING PAD


    1. Remove the rear door upper outside moulding pad.

      A018MAH