HEIGHT CONTROL SENSOR REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE REAR WHEEL LH

  4. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH


    1. A002C2G

      Disconnect the connector.

    2. Remove the bolt.

    3. Disengage the guide.

    4. A002AY8C01
      B003ZIE Bolt
      B003Z8F Nut

      Remove the bolt and 2 nuts.

    5. Disengage the guide to remove the rear height control sensor sub-assembly LH.

      Note

      Do not drop the rear height control sensor sub-assembly LH. If it is dropped, replace it with a new one.