STOP LIGHT SWITCH INSTALLATION

PROCEDURE


  1. INSTALL STOP LIGHT SWITCH ASSEMBLY


    1. A018KJE

      Insert the stop light switch assembly until the threaded sleeve hits the pedal.

      Note

      When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.

    2. A018L8AE05

      Turn the stop light switch assembly a quarter turn clockwise to install the stop light switch assembly.

      Torque:
      1.5 N*m  { 15 kgf*cm, 13 in.*lbf }
      or less

      Note

      When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.

    3. Connect the connector.

    4. Check the protrusion of the plunger.

      Part Measurement
      A 0.5 to 2.4 mm (0.0197 to 0.0945 in.)

      If the protrusion is not as specified, recheck switch installation and inspect brake pedal adjustment if necessary.

      for LHD
      Click here Click here
      for RHD
      Click here Click here

      Note

      Do not depress or support the brake pedal.

  2. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here