LICENSE PLATE LIGHT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure described below is for the LH side.

  • The license plate light bulb can be replaced by removing only the license plate light lens. It is not necessary to remove the license plate light assembly.

PROCEDURE


  1. REMOVE BACK WINDOW UPPER TRIM PANEL

    Click here

  2. REMOVE BACK DOOR TRIM COVER LH

    Click here

  3. REMOVE BACK DOOR TRIM COVER RH

    Tech Tips

    Use the same procedure as for the LH side.

  4. REMOVE BACK DOOR LOCK COVER (for Glass Hatch Type)

    Click here

  5. REMOVE NO. 2 BACK DOOR SERVICE HOLE COVER

    Click here

  6. REMOVE NO. 1 BACK DOOR SERVICE HOLE COVER

    Click here

  7. REMOVE BACK DOOR TRIM PANEL ASSEMBLY

    Click here

  8. REMOVE LICENSE PLATE LIGHT ASSEMBLY


    1. A002968

      Disconnect the connector.

    2. Disengage the 2 claws to remove the license plate light assembly.

  9. REMOVE LICENSE PLATE LIGHT BULB


    1. A0027MMC01
      *a Insert into the hole
      B004057 Protective Tape

      Insert a screwdriver wrapped with protective tape into the license plate light lens hole, tilt it as shown in the illustration and disengage the 2 claws to remove the license plate light lens.

    2. A0026UY

      Remove the license plate light bulb.