REAR COMBINATION LIGHT ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY

   
   

   1. Engage the grommet.

   2. Connect the connector to install the rear combination light socket and wire sub-assembly.

2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH (for LH Side)

   Click here

3. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH (for RH Side)

   Click here

4. INSTALL ROPE HOOK

   Click here

5. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

   Click here

6. INSTALL DECK TRIM POCKET COVER

   Click here

7. INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (for RH Side)

   Click here

8. INSTALL SIDE TRIM COVER RH (for RH Side)

   w/o Rear Automatic Air Conditioning System: Click here

9. INSTALL COOLER (NO. 2 ROOM TEMP. SENSOR) THERMISTOR (for RH Side)

   w/ Rear Automatic Air Conditioning System: Click here

10. CONNECT REAR NO. 2 SEAT OUTER BELT ASSEMBLY

    Click here

11. INSTALL DECK TRIM SIDE SERVICE HOLE COVER (for LH Side)

    Click here

12. INSTALL DECK TRIM SIDE BELT HOLE COVER RH (for RH Side)

    Click here

13. INSTALL NO. 2 DECK SIDE TRIM COVER (for LH Side)

    Click here

14. INSTALL NO. 1 DECK SIDE TRIM COVER (for RH Side)

    Click here

15. CONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY

    Click here

16. INSTALL FRONT DECK SIDE TRIM COVER

    Click here

17. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP

    Click here

18. INSTALL REAR DOOR SCUFF PLATE

    Click here

19. INSTALL REAR OUTER SEAT TRACK BRACKET COVER

    Click here

20. INSTALL REAR NO. 2 SEAT ASSEMBLY

    Click here

21. INSTALL REAR FLOOR FINISH PLATE

    Click here

22. INSTALL REAR DECK FLOOR BOX

    Click here

23. INSTALL DECK SIDE TRIM BOX LH

    Click here

24. INSTALL TONNEAU COVER ASSEMBLY

    Click here

25. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY

    Click here

26. INSTALL DECK BOARD ASSEMBLY

    Click here

27. INSTALL REAR TURN SIGNAL LIGHT BULB

    
    

    1. Install the rear turn signal light bulb to the rear combination light socket and wire sub-assembly.

28. INSTALL REAR COMBINATION LIGHT ASSEMBLY

    
    

    1. 

       Turn the rear combination light socket and wire sub-assembly with the rear turn signal light bulb as shown in the illustration to connect them as a unit.

    2. Connect the connector.

    3. Engage the 3 clamps.

    4. 

       *a	Pin
       *b	Guide

       Engage the guide and pin to temporarily install the rear combination light assembly as shown in the illustration.

    5. Install the rear combination light assembly with the 2 screws.

    6. Engage the 4 claws to install the rear combination light cover.