WASHER NOZZLE(for Front Side) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE HOOD INSULATOR (w/ Heater)

    Click here

  2. REMOVE WASHER NOZZLE SUB-ASSEMBLY (w/o Heater)


    1. A0027KJC01
      *a Protective Tape

      Using a screwdriver, disengage the 2 claws as indicated by the arrows, in the order shown in the illustration to separate the washer nozzle sub-assembly.

      Note

      Be careful not to damage the windshield glass.

      Tech Tips


      • Tape the screwdriver tip before use.

    2. A002BKH

      Remove the washer nozzle sub-assembly from the washer hose.

      Note

      Washer nozzle sub-assemblies cannot be reused.

  3. REMOVE WASHER NOZZLE SUB-ASSEMBLY (w/ Heater)


    1. A0029LXC01
      B003ZIE Connector
      B003Z8F Washer Hose

      Disconnect the connector.

    2. Disconnect the washer hose.

    3. A002AFH

      Tie a string to the wire harness of the washer nozzle sub-assembly.

    4. A002CL3N01

      Using a moulding remover, disengage the 2 claws as indicated by the arrows, in the order shown in the illustration to separate the washer nozzle sub-assembly.

      Note

      Be careful not to damage the windshield glass.

    5. A002CGQ

      Pull the washer nozzle sub-assembly as shown in the illustration from the hood sub-assembly to remove it.

      Note


      • Washer nozzle sub-assemblies cannot be reused.

      • Leave the string inside the hood sub-assembly.

    6. Remove the string from the wire harness of the washer nozzle sub-assembly.