PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL
Note
When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected:
| System | See Procedure |
|---|---|
| Lane Departure Alert System (w/ Steering Control) | |
| Parking Assist Monitor System | |
| Panoramic View Monitor System | |
| Power Door Lock Control System | |
| Pre-collision System | |
| Air Conditioning System (for Automatic Air Conditioning System) | |
| Air Conditioning System (for Manual Air Conditioning System) | |
| Power Back Door System |
IGNITION SWITCH EXPRESSIONS
The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.
| Expression | Ignition Switch (Position) | Engine Switch (Condition) |
|---|---|---|
| Ignition Switch off | LOCK | Off (Lock) |
| Ignition Switch ACC | ACC | On (ACC) |
| Ignition Switch ON | ON | On (IG) |
| Engine Start | START | On (Start) |
PRECAUTION OF WASHER NOZZLE ADJUSTMENT
Do not clean or adjust the washer nozzle with a safety pin, etc. because:
The washer nozzle tip is made of resin and could be damaged.
Adjustment is not necessary for this spray type washer nozzle. If it is necessary to change the nozzle angle, replace the washer nozzle with one that has a different nozzle angle.
If the washer nozzle is clogged with wax, etc., remove it and clean the nozzle hole with a soft resin brush or other cleaning tool.
PRECAUTIONS FOR INSPECTING POWER SOURCE FOR MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (for LHD)
As the door control battery is installed between the vehicle battery and main body ECU (multiplex network body ECU), a door control battery malfunction can be suspected if the power source for the main body ECU (multiplex network body ECU) is malfunctioning.