OUTER REAR VIEW MIRROR GLASS REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE OUTER MIRROR


    1. A018IIBC01
      B004057 Protective Tape

      Apply protective tape to the area shown in the illustration.

    2. Push the upper part of the mirror surface and tilt it.

    3. Using a moulding remover, disengage the 2 claws on the lower part of the outer mirror.

    4. A018IKFC01
      B004057 Protective Tape

      Apply protective tape to the area shown in the illustration.

    5. Push the lower part of the mirror surface and tilt it.

    6. Using a moulding remover, disengage the 2 claws on the upper part of the outer mirror.

    7. A018GUGC01
      *a Mirror Heater Connector
      *b Blind Spot Monitor Indicator Connector

      w/ Mirror Heater:


      1. Disconnect the 2 mirror heater connectors.

    8. w/ Blind Spot Monitor System:


      1. Disengage the clamp.

      2. Release the tabs of the blind spot monitor indicator connector to disconnect the blind spot monitor indicator connector.

        Note


        • Do not bend the tabs excessively to prevent them from being damaged.

        • If the tabs are damaged, replace the outer mirror with a new one.

    9. Remove the outer mirror.