FUEL LID OPENER MOTOR ASSEMBLY INSPECTION

PROCEDURE


  1. INSPECT FUEL LID LOCK WITH MOTOR ASSEMBLY


    1. Check the operation of the fuel lid lock with motor assembly.


      1. A018ISVC01
        *a

        Component without harness connected

        (Fuel Lid Lock with Motor Assembly)
        *b Shaft Stroke
        *c Lock
        *d Unlock

        Apply battery voltage to the fuel lid lock with motor assembly connector, and check that the fuel lid lock with motor assembly operates smoothly as follows.

        OK
        Connection Specified Condition

        Battery positive (+) → Terminal 1

        Battery negative (-) → Terminal 2

        		 Unlock

        If the result is not as specified, replace the fuel lid lock with motor assembly.

      2. Measure the shaft stroke.

        OK
        Area Condition Specified Condition
        Shaft stroke Unlock

        0 mm

        (0 in.)
        Lock

        10 mm

        (0.394 in.)

        If the result is not as specified, replace the fuel lid lock with motor assembly.