SLIDING ROOF HOUSING REASSEMBLY

PROCEDURE


  1. INSTALL SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY


    1. A018JPV

      Hold down the roof wind deflector panel sub-assembly.

    2. Using a screwdriver, slide the sliding roof drive cable sub-assembly as shown in the illustration to install it.

      A018HBSC01
      *a Protective Tape - -

      Tech Tips

      Tape the screwdriver tip before use.

    3. Insert the rear roof drip channel in the direction indicated by the arrow (1) in the illustration.

      A018IRNN01

    4. Engage the 2 claws in the direction indicated by the arrow (2) in the illustration to install the rear roof drip channel.

  2. ADJUST FULLY CLOSED POSITION


    1. Using a screwdriver, slide the sliding roof drive cable sub-assembly in either direction and align the alignment marks as shown in the illustration.

      A018KLEC01
      *a Alignment Mark - -

      Tech Tips

      Tape the screwdriver tip before use.

  3. INSTALL SUNSHADE TRIM SUB-ASSEMBLY


    1. A018KYQ

      Insert the sunshade trim sub-assembly into the sliding roof housing sub-assembly.

    2. Engage the guide to install the sliding roof piece sub-assembly LH.

      A018JDA

      Tech Tips

      Use the same procedure for the RH side.

    3. Install the 2 screws.

  4. INSTALL SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY


    1. A018MFQ

      Install the sliding roof drive gear sub-assembly with the 2 bolts.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }
    2. A018MGMC01
      *a Guide
      *b Pin

      Engage the guide and pin.

    3. Engage the claw to install the map light bracket.