SLIDING ROOF SYSTEM TERMINALS OF ECU


  1. CHECK SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY)

    A018IYSN29

    1. Disconnect the S5 sliding roof ECU (sliding roof drive gear sub-assembly) connector.

    2. Measure the resistance and voltage according to the value(s) in the table below.

      Tech Tips

      Measure the values on the wire harness side with the connector disconnected.

      Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
      S5-8 (B) - S5-12 (E) L - W-B Battery power supply Always 11 to 14 V
      S5-1 (IG) - S5-12 (E) V - W-B IG power supply Engine switch off Below 1 V
      S5-1 (IG) - S5-12 (E) V - W-B IG power supply Engine switch on (IG) 11 to 14 V
      S5-12 (E) - Body ground W-B - Body ground Ground Always Below 1 Ω

    3. Reconnect the S5 sliding roof ECU (sliding roof drive gear sub-assembly) connector.

    4. Measure the voltage according to the value(s) in the table below.

      Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
      S5-7 (OPN) - S5-12 (E) Y - W-B OPEN switch input signal Engine switch on (IG), OPEN switch on Below 1 V
      S5-7 (OPN) - S5-12 (E) Y - W-B OPEN switch input signal Engine switch on (IG), OPEN switch off 11 to 14 V
      S5-5 (CLS) - S5-12 (E) R - W-B CLOSE switch input signal Engine switch on (IG), CLOSE switch on Below 1 V
      S5-5 (CLS) - S5-12 (E) R - W-B CLOSE switch input signal Engine switch on (IG), CLOSE switch off 11 to 14 V
      S5-4 (UP) - S5-12 (E) W - W-B UP switch input signal Engine switch on (IG), UP switch on Below 1 V
      S5-4 (UP) - S5-12 (E) W - W-B UP switch input signal Engine switch on (IG), UP switch off 11 to 14 V
      S5-6 (DWN) - S5-12 (E) V - W-B DOWN switch input signal Engine switch on (IG), DOWN switch on Below 1 V
      S5-6 (DWN) - S5-12 (E) V - W-B DOWN switch input signal Engine switch on (IG), DOWN switch off 11 to 14 V

  2. CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY

    Click here