POWER WINDOW REGULATOR MOTOR(for Rear Door) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  4. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL

    Click here

  5. REMOVE REAR DOOR REAR GUIDE SEAL

    Click here

  6. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  7. REMOVE REAR DOOR SERVICE HOLE COVER

    Click here

  8. REMOVE REAR DOOR PANEL PROTECTOR

    Click here

  9. REMOVE REAR DOOR GLASS RUN

    Click here

  10. DISCONNECT REAR DOOR WEATHERSTRIP


    1. A002CAP

      Disconnect the rear door weatherstrip as shown in the illustration.

  11. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY

    Click here

  12. REMOVE REAR DOOR GLASS SUB-ASSEMBLY

    Click here

  13. REMOVE REAR DOOR WINDOW REGULATOR ASSEMBLY

    Click here

  14. REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY


    1. A002AEE

      Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor assembly.