CAUTION / NOTICE / HINT
Tech Tips
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE
INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY
Note
The regulator arm must be below the intermediate position when installing the power window regulator motor assembly.
Using a T25 "TORX" socket wrench, install the power window regulator motor assembly with the 3 screws.
Tech Tips
When replacing the power window regulator motor assembly, a new power window regulator motor assembly uses self-tapping screws to thread new installation holes when the self-tapping screws are installed.
INSTALL FRONT DOOR WINDOW REGULATOR ASSEMBLY
INSTALL FRONT DOOR GLASS SUB-ASSEMBLY
INSTALL FRONT DOOR SERVICE HOLE COVER
INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY
INSTALL COURTESY LIGHT ASSEMBLY
INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)
INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)
INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG
INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
INITIALIZE POWER WINDOW CONTROL SYSTEM
for Models with Jam Protection Function on 4 Windows:
for Models with Jam Protection Function on Front Door Windows:
INSPECT POWER WINDOW OPERATION
for Models with Jam Protection Function on 4 Windows:
for Models with Jam Protection Function on Front Door Windows: