POWER WINDOW REGULATOR MOTOR(for Front Door) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH

    Click here

  4. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  5. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)

    Click here

  6. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)

    Click here

  7. REMOVE COURTESY LIGHT ASSEMBLY

    Click here

  8. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  9. REMOVE FRONT DOOR SERVICE HOLE COVER

    Click here

  10. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY

    Click here

  11. REMOVE FRONT DOOR WINDOW REGULATOR ASSEMBLY

    Click here

  12. REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY


    1. A002BES

      Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor assembly.