FRONT EVAPORATOR TEMPERATURE SENSOR INSTALLATION

PROCEDURE


  1. INSTALL NO. 1 COOLER THERMISTOR


    1. A018I3PC01
      *a Fixed Part
      *b Sensor Part

      Install the No. 1 cooler thermistor as shown in the illustration.

      Installation Position
      Part Length
      A 34.3 mm (1.35 in.)
      B 20.9 mm (0.823 in.)
      C 50.0 mm (1.97 in.)

      Note


      • Be sure to insert the No. 1 cooler thermistor only once because reinserting it into the same position will not allow it to be firmly secured.

      • When reusing the No. 1 cooler evaporator sub-assembly, insert the No. 1 cooler thermistor one row next to the one that has been used previously (X in the illustration).

      • After inserting the No. 1 cooler thermistor, do not apply excessive force to the wire.

      • Directly insert the No. 1 cooler thermistor until the edge of the plastic case "a" comes into contact with the No. 1 cooler evaporator sub-assembly "b".

  2. INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY

    Click here

  3. INSTALL BLOWER ASSEMBLY WITH COOLER EVAPORATOR SUB-ASSEMBLY

    Click here