REAR DOOR LOCK INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH side.

  • The procedure described below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY

    Click here

  3. INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY

    Click here

  4. INSTALL REAR DOOR LOCK WITH MOTOR ASSEMBLY

    Note


    • When reusing a removed rear door lock with motor assembly, replace the door lock wiring harness seal with a new one.

    • Do not allow grease or dust to adhere to the door lock wiring harness seal installation surface.

    • Reusing a door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water ingress. This may result in a malfunction of the rear door lock with motor assembly.


    1. Apply MP grease to the sliding parts of the rear door lock with motor assembly.

    2. When reusing the rear door lock with motor assembly:


      1. A0028PC

        Install a new door lock wiring harness seal to the rear door lock with motor assembly.

    3. A0028R0C01
      *a Release Plate

      Connect the rear door lock with motor assembly to the release plate of the rear door outside handle frame sub-assembly, and set it to the rear door panel.

      Tech Tips

      Make sure that the release plate of the rear door outside handle frame sub-assembly is securely connected to the rear door lock with motor assembly.

    4. Using a T30 "TORX" socket wrench, install the rear door lock with motor assembly with the 3 screws.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

  5. INSTALL REAR DOOR GLASS SUB-ASSEMBLY

    Click here

  6. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY

    Click here

  7. INSTALL REAR DOOR GLASS RUN

    Click here

  8. CONNECT REAR DOOR WEATHERSTRIP

    Click here

  9. INSTALL REAR DOOR PANEL PROTECTOR

    Click here

  10. INSTALL REAR DOOR SERVICE HOLE COVER

    Click here

  11. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  12. INSTALL REAR DOOR REAR GUIDE SEAL

    Click here

  13. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL

    Click here

  14. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  16. INITIALIZE POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on 4 Windows)

    Click here

  17. INSPECT POWER WINDOW OPERATION


    • for Models with Jam Protection Function on 4 Windows:

      Click here


    • for Models with Jam Protection Function on Front Door Windows:

      Click here