REAR DOOR LOCK REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. PRECAUTION

   Note

   After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

   Click here

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here

3. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG

   Click here

4. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL

   Click here

5. REMOVE REAR DOOR REAR GUIDE SEAL

   Click here

6. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

   Click here

7. REMOVE REAR DOOR SERVICE HOLE COVER

   Click here

8. REMOVE REAR DOOR PANEL PROTECTOR

   Click here

9. DISCONNECT REAR DOOR WEATHERSTRIP

   Click here

10. REMOVE REAR DOOR GLASS RUN

    Click here

11. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY

    Click here

12. REMOVE REAR DOOR GLASS SUB-ASSEMBLY

    Click here

13. REMOVE REAR DOOR LOCK WITH MOTOR ASSEMBLY

    
    

    1. 

       *a	Release Plate

       Using a T30 "TORX" socket wrench, remove the 3 screws.

    2. Move the rear door lock with motor assembly downward to disconnect it from the release plate of the rear door outside handle frame sub-assembly, and remove the rear door lock with motor assembly.

    3. When reusing the rear door lock with motor assembly:

       
       

       1. 

          Remove the door lock wiring harness seal from the rear door lock with motor assembly.

14. REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY

    Click here

15. REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY

    Click here