FRONT DOOR LOCK INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH side.

  • The procedure described below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. INSTALL FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY

    Click here

  3. INSTALL FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY

    Click here

  4. INSTALL FRONT DOOR LOCK WITH MOTOR ASSEMBLY

    Note


    • When reusing a removed front door lock with motor assembly, replace the door lock wiring harness seal with a new one.

    • Do not allow grease or dust to adhere to the door lock wiring harness seal installation surface.

    • Reusing a door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water ingress. This may result in a malfunction of the front door lock with motor assembly.


    1. Apply MP grease to the sliding parts of the front door lock with motor assembly.

    2. When reusing the front door lock with motor assembly:


      1. A00287G

        Install a new door lock wiring harness seal to the front door lock with motor assembly.

    3. A002BFRC03
      *1 Front Door Lock Open Rod

      Connect the front door lock open rod to the front door lock with motor assembly.

      Tech Tips

      Make sure that the front door lock open rod is securely connected to the front door lock with motor assembly.

    4. Using a T30 "TORX" socket wrench, install the front door lock with motor assembly with the 3 screws.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

    5. Connect the connector.

  5. INSTALL FRONT DOOR OUTSIDE HANDLE COVER WITH LOCK CYLINDER ASSEMBLY (for Driver Side)

    Click here

  6. INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY

    Click here

  7. INSTALL FRONT DOOR GLASS RUN

    Click here

  8. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

    Click here

  9. INSTALL FRONT DOOR SERVICE HOLE COVER

    Click here

  10. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  11. INSTALL COURTESY LIGHT ASSEMBLY

    Click here

  12. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)

    Click here

  13. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)

    Click here

  14. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  15. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH

    Click here

  16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  17. INITIALIZE POWER WINDOW CONTROL SYSTEM


    • for Models with Jam Protection Function on 4 Windows:

      Click here


    • for Models with Jam Protection Function on Front Door Windows:

      Click here

  18. INSPECT POWER WINDOW OPERATION


    • for Models with Jam Protection Function on 4 Windows:

      Click here


    • for Models with Jam Protection Function on Front Door Windows:

      Click here