UNLOCK WARNING SWITCH INSPECTION

PROCEDURE


  1. INSPECT UNLOCK WARNING SWITCH ASSEMBLY

    A018JFDC12
    *a

    Component without harness connected

    (Unlock Warning Switch Assembly)
    *b Switch not pushed
    *c Switch pushed

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 - 2 Switch not pushed (Key removed) 10 kΩ or higher
      1 - 2 Switch pushed (Key inserted) Below 1 Ω

      If the result is not as specified, replace the unlock warning switch assembly.