WIRELESS DOOR LOCK CONTROL SYSTEM(w/o Smart Entry and Start System) DIAGNOSIS SYSTEM


  1. CHECK DLC3


    1. Check the DLC3.

      Click here

  2. INSPECT BATTERY VOLTAGE


    1. Measure the vehicle battery voltage.

      If the voltage is below 11 V, recharge or replace the battery.

    2. SELF-DIAGNOSTIC MODE (USING GTS)


      1. Connect the GTS to the DLC3.

      2. Turn the ignition switch to ON.

      3. Turn the GTS on.

      4. Enter the following menus: Body Electrical / Main Body / Utility / Wireless Door Lock Diagnosis Mode.


        Body Electrical > Main Body > Utility
      3. Tester Display
      Wireless Door Lock Diagnosis Mode

  • Proceed to the next step in accordance with the prompts on the GTS screen.

  • A002BZLE44
    Interior Light Output
    *1 ON
    *2 OFF
    *3 T1: 0.25 seconds
    *4 T2: 0.5 seconds

    Check that the system has switched to self-diagnostic mode by checking the interior light output pattern.

  • Check the diagnostic outputs when a door control transmitter module set sub-assembly switch is pressed. The diagnostic outputs can be checked by the interior light flash pattern.

    A0027OGE05
    Result
    Interior Light Output Suspected Area
    A Normal (No malfunction)
    B Register wireless code
    C Wave interference or malfunction of a related component