GENERATOR REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE FAN SHROUD

    Click here

  4. REMOVE NO. 2 ENGINE OIL LEVEL DIPSTICK GUIDE

    Click here

  5. REMOVE V-RIBBED BELT

    Click here

  6. REMOVE GENERATOR ASSEMBLY


    1. A002B3S

      Open the terminal cap.

    2. Remove the nut and disconnect the wire harness from terminal B.

    3. Disconnect the generator assembly connector from the generator assembly.

    4. Disconnect the compressor and magnetic clutch connector.

    5. Disconnect the 3 wire harness clamps.

    6. A002CC8

      Remove the 2 bolts and then disconnect the generator assembly bracket.

    7. A002CLQ

      Remove the 2 bolts and generator assembly.

    8. A00288N

      Disconnect the wire harness clamp and then remove the generator assembly bracket.

    9. A002BWB

      Remove the bolt and wire harness clamp bracket.